Commercial plumbing
Washroom plumbing for offices and shops
Commercial washrooms use different hardware from a house: flushometers, carriers, sensor taps and urinals that run all day. We stock the parts and fix them in one visit where we can.
or dial (365) 363-3352Visits booked around your hours
- Flushometer diaphragms and vacuum breakers rebuilt
- Urinals and wall-hung toilets cleared and reset
- Sensor and metering taps repaired
- Mop sinks and small tank heaters serviced
A price before we startNothing cut or opened until you say yes.
- Licensed & insureddetails confirmed on the call
- Phones answered 24/7a person, not a queue
- Price before we startcall-out rate on the phone
- Old Toronto & East Yorkhouses, condos, businesses
Hardware we work on
- Flushometer valves: manual and sensor, on toilets and urinals.
- Wall-hung fixtures: toilets and urinals on carriers, with the seals and bolts behind the wall.
- Taps: sensor faucets, metering push taps and mixing valves.
- Back-of-house: mop sinks, eyewash supply, small electric or gas tank heaters.
Signs it is time to call
- Urinal or toilet flushing continuously
- Water on the floor at a wall-hung toilet
- Sensor tap that drips or will not start
- Slow urinal drains with a sharp smell
Common washroom calls
Toilet or urinal that runs on
Usually a worn diaphragm or a bypass hole clogged with scale inside the flushometer. A rebuild kit and a few minutes with the stop closed usually fixes it.
Urinal that will not drain
Urinal lines collect uric scale that narrows the trap arm. We cable it and, on stubborn lines, descale before the fixture is reset.
Leak at a wall-hung toilet
The gasket between bowl and carrier fails or the carrier bolts loosen. We lift the bowl, replace the gasket and torque it down evenly.
Keeping the store or office open
- We book visits before opening or after close where possible.
- One washroom is kept working while the other is repaired.
- Parts for the common flushometer brands travel on the truck.
What’s included
What’s included
- Flushometer rebuild or replacement
- Urinal and toilet line clearing
- Carrier gasket and bolt service
- Tap and mixing valve repair
How the visit runs
- 1Isolate
Fixture stop closed, one washroom kept in service.
- 2Diagnose
Valve opened, trap arm cabled or carrier checked.
- 3Rebuild
Kit fitted or fixture replaced.
- 4Test
Several flush cycles watched before we leave.
Common questions
Can you fix a flushometer without replacing it?
Often, yes. Most leaks and run-ons come from the diaphragm or seals, which come in rebuild kits.
Do you do washroom renovations for stores?
We handle the plumbing side of a fit-out or refresh: rough-in, carriers, fixtures and connections, working with your contractor.
Keep the doors open. Call the plumber.
A plumber answers day and night, and the call-out rate is quoted before anyone drives over.